Fireplaces in San Diego CA

Fireplace Mantel In San Diego
Mantel Depot Fireplace Mantel with Over Mantel

Fireplaces in San Diego

Mantelpiece, sometimes referred to as fireplace mantels, and grate styles have changed but the basic structural elements of a fireplace have not radically changed for hundreds of years. The early combination of a large stone or brick opening with a smokestackbuilt over it evolved from the obvious fact that smoke rises, rather than from a scientific understanding of how a well-designed chimney system works. Consequently early wood and later coal-burning fires were very inefficient and it was not until a certain Benjamin Thompson produced his thesis on the principles of fireplace mantels design in 1799 that smaller grates and improvements in the internal shape of the openings were introduced.

San Diego Fireplaces

A brick or stone enclosure forms the basis of the fireplace. Variously known as the fireplace opening or recess or builders opening, it may be set flush with the wall or built out into the room, forming a chimney breast. This chimney breast rises through the height of the house, emerging through the roof to form a chimney stack. At the top of the opening the gather and flue combine to carry the smoke up the chimney. If the chimney is shared by several fireplaces on different floors, it may contain more than one flue.

The masonry over the fireplace opening is supported by a lintel or a brick arch. Old inglenook fireplaces used colossal oak beams, whereas a strong iron strap usually supports an early brick arch. Later fireplaces may have a straight arch supported by angle iron, and by the twentieth century cast concrete lintels were the norm.

A hearth, constructed from non-combustible materials such as stone or tile-faced concrete, projects out into the room to protect the floor from falling ashes. In most old houses the hearth was set flush with the floor, although sometimes a superimposed one was used to raise the level. The space within the fireplace opening, known as the back hearth, is usually level with the hearth itself. A dog grate for burning wood or coal can be placed on this back hearth. However, by the mid-nineteenth century the mass produced cast-iron register grate which filled the opening, had become the fashion.

To finish the assembly, a mantelpiece or fireplace mantel – or fireplace surround, as it is often called today – is fitted to frame the grate or fireplace opening. The fireplace mantel may be constructed from stone, slate, marble, wood or cast iron. The walls around it may be finished with wood paneling, or more generally with plaster, and in some cases the fireplace mantel extends upwards to form an impressive chimneypiece. Mirrored overmantels were introduced in the late eighteenth century, and these became the classic feature of Victorian sitting rooms.

From Mantel Depot

Functionality of Fireplace Mantels

Within this fireplace an open fire burning wood or coal is a cheerful sight, but if it is your only source of warmth, as it was for centuries, this romantic image can soon fade especially if the fire does not burn properly. Getting a fire started and keeping it burning then becomes a challenge, if not a chore. For wood and coal fires to burn well a good supply of air is needed under the grate, as well as a means of escape for the hot gases and smoke. With the fuel carefully contained within the fireplace opening on a grate, free movement of air is achievable and waste ash can fall through the grate so the fire is not stifled. If the chimney is inadequate or the flow of air is restricted the fireplace mantels will not operate effectively.

Fireplace Mantels in San Diego
Fireplace Surrounds in San Diego

Fireplace Mantels – The Early Styles

In the early evolution of the fireplace mantel – from the primitive wood or peat fire lit on a slab of stone during the Saxon times through the mediaeval period when the fireplace mantel evolved into a considerably more efficient edifice – the most important room was the common hall.
The Saxon dwelling, whether it was a royal castle, a manor house, or a lowly one-room cottage, was built around the fireplace. Rooms could be added on at different stages of the life of the house, but the fireplace was the hub of early English domestic life, providing heat to cook food, boil water and warm the inhabitants. The common hall was usually on the ground floor, and was open to the roof. The fire would be placed in the center of the room and the smoke would drift out through open windows, crevices in the eaves – or sometimes through a hole in the roof created for this purpose. Coal was less objectionable than wood when burnt in close quarters like this, but the residents would have had to sleep around the fire at night to keep warm, so even when using coal life must have been very uncomfortable. Recessed fireplaces with chimneys were installed as early as the twelfth century in other rooms in the house, but even though the central fireplace was such an important part of domestic life, chimneys did not come into general use in the central hall until the early sixteenth century. Smoke turrets or louvers were introduced during the reign of Henry III according to written records, although there are no examples still in existence. Initially they were built solely for the purpose of assisting the smoke out of the building, but gradually the chimney stack evolved as a highly decorative architectural ornament. These decorative architectural ornaments were called fireplace mantels.
The modern day fireplace mantel originates from the early Norman times. Unlike the single story Saxon dwelling, the Norman household was frequently set out over two stories and therefore could not accommodate the Saxon method of allowing the smoke to drift out through the rafters. Early fireplace mantels were large, slightly cambered hoods, supported on stone jambs or corbels. The recesses of the capacious fireplace could contain niches in the back wall, where a clay pipe or cup could be placed. There would be sufficient room to hang cuts of meat so that they could be smoke-cured.
By the start of the Tudor period, the fireplace mantels had evolved from a huge overhanging stone hood, sometimes even supported by columns, to a more discreet affair. There was sufficient area around the fire to allow a number of people to huddle close to the warmth, and occasionally a bench would be set into the fireplace for comfort. The lintel was generally a single heavy beam and the opening of the fireplace was usually wide and rectangular to permit sufficient drought to oxygenate the flames.
Sometimes the kitchen fireplace even had an ingenious system of shelving installed on each side of the hearth-the shelves were narrow and ran from back to front of the fireplace and were used for baking loaves. Special flat shovels called “peles” were needed to retrieve loaves placed at the back of the oven. A surprisingly small number of these ovens have been discovered, so it can only be assumed that bread was so cheap to buy that the time and labor cost of producing loaves at home could not be economical.
Meat provided a much large proportion of the mediaeval diet than it does in the twenty-first century. Roasting spits, a tool used for roasting large pieces of meat, were used for cooking the meat over a fireplace. The meat would be taken up to the table and served directly off the spit. New types of spit and turning mechanisms were gradually brought into play, although it was not until the second half of the sixteenth century that clockwork or draught-operated devices started to catch on, in an early attempt to cut down time-wasting chores. There was even a small breed of dog known as a “turnspit”, which had been specially trained to operate the spits by walking on a wheel or drum fixed height on the wall near the fireplace. The treadmill was attached to the spit by a spindle. It was not a happy profession for a small animal, particularly if he was turning the spit for a large joint of meat to feed a large crowd. Dogs continued to be used until the early part of the nineteenth century, when oven-cooked meat became the norm.
Early fireplace mantels were quite simple and unadorned, a practical design with no decorative appeal other than an occasional simple rope detail around the surround. Towards the middle of the 16th century, not only were the fireplace mantels becoming more ornate, but so were the surrounds and overmantels. The fireplace mantels around this time often show the disjointed nature of fireplace design as old snatches of information from Renaissance Italy were taken out of context by noblemen trying to flaunt their wealth and status. These were applied to the fireplace at will, often mixing design styles such as Classical, Heraldic and traditional in one piece. Generally there is very little consistency in the fireplace mantel design during the transitional period of the early 16th century Gothic, Classical Italian, Heraldic, and French styles were all experimented with by different architects. The design often fought with the practical aspects of the fireplace, and with the materials available in the region.
by John Pham, www.MantelDepot.com

Fireplace Mantel Styles – Form, Function, and Design through the Years

The fireplace mantel is familiar to us all as a symbol of home and comfort. Yet as universal as the fireplace mantel may seem, it has meant different things at different times in history-serving once not only as a source of heat, but as a means of cooking, with some fireplace mantels reaching an enormous width that could accommodate several cooks and roasting joint. Fireplace mantel or simply mantel, also known as fireplace surround, hood, or any other similar projection, usually ornamented, that surround the opening of a fireplace that directs smokes to the chimney flue originated in medieval times as a hood that projected over a grate to catch the smoke. The term has evolved to include the decorative framework, usually stone, around the fireplace, and can include elaborate designs extending to the ceiling, also known as over-mantels. Mantel is now the general term for the jambs, mantel shelf, and external accessories of a fireplace. For many centuries, the mantel was the most ornamental and most artistic feature of a room, but as fireplaces have become smaller, and modern methods of heating have been introduced, its artistic as well as its practical significance has lessened.

Fireplace mantels of early days
Up until the twelfth century, fires were simply made in the middle of a home by fires on the hearth with smoke vented out the lantern in the roof. As time went on, the placement of fireplaces moved to the wall, incorporating chimneys to vent the smoke. This permitted the design of a very elaborate, rich, architectural focal point for a grand room.
The earliest known fireplace mantel is in the Kings House at Southampton, with Norman shafts in the joints carrying a segmental arch, which is attributed to the first half of the twelfth century. At a later date, in consequence of the greater width of the fireplace, flat or segmental arches were thrown across and constructed with archivolt, sometimes joggled, with the thrust of the arch being resisted by bars of iron at the back.
In domestic work of the fourteenth century, the fireplace mantel was greatly increased in order to allow of the members of the family sitting on either side of the fire on the hearth, and in these cases great beams of timber were employed to carry the hood; in such cases the fireplace was so deeply recessed as to become externally an important architectural feature, as at Haddon Hall. The largest fireplace mantel existing is in the great hall of the Palais des Comtes at Poitiers, which is nearly 30 feet wide, having two intermediate supports to carry the hood; the stone flues are carried up between the tracery of an immense window above.
The history of carved mantels is a fundamental element in the history of western art. Every element of European sculpture can be seen on great mantels. Many of the historically noted sculptors of the past i.e. Augustus St. Gaudens designed and carved magnificent mantels, some of which can be found on display in the world’s great museums. Exactly as the facade of a building is distinguished by its design, proportion, and detail so it is with fine mantels. The attention to carved detail is what defines a great mantel.

Fireplace mantels today
Up to the late 20th century and the invention of central-air heating systems, rooms were heated by an open or central fire. A modern fireplace mantel usually serves as an element to enhance the grandeur of an interior space rather than as a heat source. However, most modern fireplace still have real fire in them because the intense feeling of personal security that a real fire projects-with its leaping flames and warm, cozy light-can never be replaced or reproduced within rooms with artificial forms of heating. Today, fireplace mantels of varying quality, materials and style are available worldwide. The fireplace mantels of today often incorporate the architecture of two or more periods or cultures.
By John Pham, Mantel Depot, Inc. www.MantelDepot.com